Authorized dealer · Car Audio Bargain

Monoblock Amplifiers

Monoblock amplifiers put all of their power into a single channel, which makes them the standard choice for driving subwoofers. Car Audio Bargain, an authorized dealer, carries mono sub amps from Sundown Audio, Crossfire and Audio Apex, from the Crossfire C3-500D and C5-800D up to Sundown SIA amps, the Audio Apex CAB-45v2 and Crossfire BMF competition models.

  • 35 products
  • Audio Apex · Crossfire Car Audio · Sundown Audio
  • Free shipping over $250
Back to Amplifiers

35 products

Choosing a Mono Amp for Your Subwoofers

Start with sub power and final impedance

Total the RMS rating of every sub in the enclosure, then wire the voice coils to a final load the amp is rated to handle. Dual voice coil drivers give more choices: two dual 4 ohm subs, for example, can be wired to either 1 ohm or 4 ohm. Pick the amp whose RMS output at that final load comes close to the subs' combined rating.

Size the amp to the build

A single sub in a daily driver rarely needs more than one of the monoblock amplifiers under 1,500W. Multi-sub walls and SPL vehicles move up to the 4,500W+ range, where the charging system matters as much as the amp. Leaving modest headroom is fine; running an amp flat out with the gain cranked is not.

Single-Channel Series by Brand

  • Sundown Audio: SAEv4 mono amps for daily systems, SFB and SIA full-range mono designs, and SALT amps that climb into competition power.
  • Crossfire Car Audio: the C3-500D, C5-800D, C5-1600D, C7-2K and C7-4K for street builds, plus the CFM 1000, XT-6K and BMF 8k and BMF 12K for heavy loads.
  • Audio Apex: the CAB-22 rated at 2,200 watts RMS and the CAB-45v2 rated at 4,500 watts RMS.

Wiring and Electrical Support

Bass amps draw serious current on every note, so power and ground wire should be sized for the draw and the length of the run. Smaller builds are covered by a complete amp wiring kit, while bigger monoblock amplifiers often need 1/0 AWG power wire with a fuse close to the battery. Set the low-pass filter and subsonic filter to suit the enclosure, then set gain with test tones so the amp stays out of clipping. For speaker amps and more options, return to all amplifiers.