Authorized dealer · Car Audio Bargain

Full Tilt Audio

Wiring holds every system together, and Full Tilt Audio builds it from 100% OFC: power and ground cable in 1/0, 4 and 8 AWG across a wide range of colors, complete amplifier wiring kits, OFC speaker wire, and HQ Series RCA interconnects and strapping cables.

Ring terminals, fuses and color-matched heat shrink finish the job. Car Audio Bargain is an authorized dealer, and wire sells by the spool and by the foot where noted.

  • 116 products
  • Full Tilt
  • Free shipping over $250
Full Tilt Audio OFC wire

116 products

Sizing Power Wire by Current and Length

Choose wire gauge from two numbers: how much current your amplifiers draw and how far the cable runs from the battery. Longer runs and higher current both call for thicker wire, because resistance builds over distance and shows up as voltage drop at the amp. As a general guide, 8 AWG suits small amplifiers on short runs, 4 AWG covers many single-amp systems, and 1/0 AWG is the common choice for high-power monoblocks and multi-amp builds. When in doubt, go one size larger.

Full Tilt Audio uses 100% OFC throughout. Pure copper conducts better than copper-clad aluminum, so an OFC cable carries more current with less voltage drop than a CCA cable of the same gauge.

Amp kits or cable by the foot

The Full Tilt 1/0 AWG and 4 AWG OFC amplifier wire kits come in color pairs such as red/black, blue/black, purple/black, teal/black, white/black and lime green/black. A kit is the quick route for a single amplifier. For multi-amp systems, buying cable by the foot lets you size each run, and our 1/0 AWG power wire collection covers longer runs. More options are in amp wiring kits.

Grounds, Fuses and Signal

  • Ground: match ground cable to the power cable gauge and keep it short, bolted to clean bare metal.
  • Fuses: place the main fuse close to the battery, commonly within 18 inches, and size it to protect the wire rather than the amp. Full Tilt Audio fuses such as the 150A sit alongside ring terminals here.
  • Speaker wire: 12 AWG OFC speaker wire, such as the 100 foot red/black spool, suits high-power speaker and subwoofer runs.
  • Signal: HQ Series RCA cables carry a clean signal to the amp, and the HQ Series single side strapping cable links amplifiers set up to run together.

Finishing Touches

Color-matched heat shrink seals each terminal against moisture and corrosion and gives the install a tidy look. Picking power cable colors that suit your build theme ties the trunk together, and running power and signal cables down opposite sides of the vehicle helps keep alternator whine out of the audio.